CRAFTSMAN CMHT68001 Ratcheting Screwdriver Multi-Bit Set, 26-Piece

The CMHT68001 is a mid-market ratcheting screwdriver built from chrome-vanadium steel (confirmed from the Amazon specifications table) with a bi-component TPR over-mold handle in three ergonomic zones — a speed zone for fast run-down, a torque zone with added grip geometry for stubborn fasteners, and a precision tactile zone for delicate work. The 18-bit kit covers PH1, PH2, and PH3 Phillips; four flathead sizes (SL 3/16, two SL 5/32, SL 1/4); Torx T6, T8, T10, T15, T20, T25, and T27; Robertson SQ1, SQ2, and SQ3; and hex H 1/8 through H 1/4, plus six 1/4-in-drive nut drivers and a telescoping magnetic pick-up tool, all in a carrying case. The Torx range exceeds the automotive trim minimum (T15/T20/T25) and extends to T27 for drivetrain and brake work. One 2020 verified-purchase review confirms the PH3 tip seats in the ratchet head without falling through; no independent forum corroboration (r/MechanicAdvice, Garage Journal) for this ASIN has been located, so the tip fitment rating reflects that gap. A known design characteristic: the extension shaft must be extended to its first notch for the lock ring to engage — it does not lock fully retracted — which affects how the set fits in the carrying case.

The right pick for a home mechanic or car owner who needs a single set for automotive interior, trim, and underhood work — the T6–T27 Torx range, all three Phillips sizes, Robertson, and six nut-driver sizes cover the full fastener matrix without a supplement. The magnetic telescoping pick-up tool adds genuine utility for recovering fasteners dropped into tight cavities. Skip this as a precision electronics or sub-compact fastener tool; the minimum tip size starts at PH1 Phillips, which is too large for subcompact board screws. Also skip if strong bit magnetism at the primary ratchet head is a requirement — the ratchet bit receiver is not magnetized, and bits seated directly in the head rely on friction retention.

Steel and synthetic polymer (TPR) construction with no SDS — no chemical exposure pathway in normal hand-tool use. The chrome-plated bar and CrV steel tips are confirmed mid-market construction; no above-average chrome flaking has been documented in the available review sample. Steel shafts and tips are among the most recyclable consumer materials; the primary environmental differentiator in this category is service life — a CrV set that holds up through multiple years of regular use displaces the replacement cycles common with commodity soft-steel alternatives. Any compound used alongside this tool — thread-locker, penetrating oil, anti-seize — carries its own hazard profile; check the individual product file for PPE guidance on those materials.